Public Lab Wiki documentation


Air Sensors

This is a revision from January 09, 2018 16:47. View all revisions
2 | 13 | | #15366

« Back to Sensors

Choosing Sensors

Often the first step is to look for a sensor for what you're hoping to measure. Below we're collecting info on different kinds of water quality sensors, and their:

  • cost
  • sensitivity/accuracy
  • links and documentation

Can you afford a sensor? Can it detect what you're looking for? Where can you learn more about it?

https://publiclab.org/w/pm-monitoring#Regulatory+grade+PM+monitoring

(this section under construction)

Drivers for Arduino + Raspberry Pi are available for the following devices:

Questions

Title Author Updated Likes Comments
How to connect an anemometer to an air particulate monitor? @crispinpierce over 3 years ago 0
What are your experiences using low-cost VOC sensors outdoors? And other questions about accuracy. @bhamster about 4 years ago 4
Have you used surveys to inform open hardware development? @kgradow1 over 4 years ago 1
Questions about Plantower sensors from the University of Wisconsin - Eau Claire @OrionAllgaier almost 6 years ago 5
Should the Purple Air be co-located with a weather station? @stevie almost 6 years ago 2
Why are the PM10 particles of the Purpleair monitor biased so high? @Cbarnes9 about 6 years ago 7
What type of aerosol was used for the calibration of the purpleair lasers? @Cbarnes9 about 6 years ago 5
Does particle composition that the purple air monitors measure greatly skew the data output? @Cbarnes9 about 6 years ago 4
How can we connect a PMS5003 dust sensor to an Arduino? @warren about 6 years ago 10
Looking for hands-on help with a datalogger! @Bronwen over 6 years ago 3
what data-logger will work with my portable HCHO meter? @nshapiro over 6 years ago 44
The difference between medical particle monitoring and your particle monitoring? @Ag8n almost 7 years ago 4
3 particle type @Ag8n almost 7 years ago 0
What different electronic particulate pollution sensors are available and at what cost? @warren almost 7 years ago 4
How good is the PurpleAir sensor and what does it detect? @warren almost 7 years ago 12
What are some ways to collect dust or particulate samples for analysis? @warren about 7 years ago 4
Is the dustduino (with Shinyei sensor) appropriate for use to study particulates at high altitude (100,00ft)? @rickwoodrickle almost 10 years ago 1
Is it possible to log the data from a dustduino without a wifi network? @kp55 almost 10 years ago 3

This is part of:

99 notes
created by warren over 6 years ago
sensors

13 following

Follow

9 notes
created by warren about 7 years ago
dylos

0 following

Follow

2 more  

0 notes
created by warren over 6 years ago
sidebar:none