Public Lab Research note


build of the microscope kit

by luglimbe | | 107 views | 1 comments |

Read more: publiclab.org/n/17148


yesterday we build the microscop we get from publiclab. it was not difficult and as you see on the image above, the result is ok. it would be good if we could measure the object we see with the microscope.

thanks for your help.

linux friends limbe south west region cameroon


1 Comments

Hi @luglimbe - Thanks for sharing your microscope image! If you're interested in measuring objects, you may want to consider using a calibration slide-- a calibration slide is simply a glass slide with a very small ruler printed on it. Sometimes it is possible to place your sample directly on the calibration slide, but you can also just take a picture of the ruler with your microscope (as long as you are using the same lens and setup for the calibration slide photo and your sample this should work reasonably well) and compare your images to that photo to find the measurement.

Below is an image I took of some beach sand with a calibration slide-- each of the lines represents 1/100 of a millimeter.

You might also find this post from @partsandcrafts helpful: Testing And Calibrating Your Microscope

A few more calibration methods are discussed here:

Microscope Calibration Overlays from @MaggPi

Use of a 5 Bill for Microscope Calibration from @amirberAgain

Photo_on_8-16-18_at_3.12_PM.jpg


Login to comment.

Public Lab is open for anyone and will always be free. By signing up you'll joined a diverse group of community researchers and tapped into a lot of grassroots expertise.

Sign up