List of parts

• 3 injection molded plastic (ABS) parts
• 2 short screws
• 2 long screws
• black paper liner
• diffraction grating
• protective film
• precision printed slit
• jewelers screwdriver

Instructions

1. Carefully pull out the grating without getting dust or fingerprints on it, and lay it ...
2. Place the double-sided tape on the interior of the molded plastic parts as shown
4. ...magic...

Sketchup model: smartphone-spec-overview.skp

Mathew's Assembly Run

• 3 injection molded plastic (ABS) parts
• 2 short screws
• 2 long screws
• 1 short black paper liner (5cm x 4cm)
• 1 long black paper liner (5cm x 8cm)
• 6 5cm lengths of double-sided tape
• 1 5cm black foam tape
• diffraction grating (5cm x 4.4cm) *protective film I did without-- this extra step increases the chances of damaging the grating in order to protect it.
• precision printed slit
• jewelers screwdriver
• razor blade

See full image set here

Adhesive options

Here's a list of other adhesives and tape strips which may be helpful in assembling and mounting the spectrometer. Some may be shipped in the kits:

• Tape strips are sold for costumes and wigs: http://www.amazon.com/Bonding-Double-Tape-Walker-Straight/dp/B00D7LA162/
• 3M's super strong 300LSE in letter sheets, ~$12 each: http://www.amazon.com/9474LE-super-strong-double-sided-adhesive-transfer/dp/B00CCGK31G/
• Scrapbooking tape strips: http://www.amazon.com/Double-sided-adhesive-mounts-12-pack/dp/B00D5WDZXO/ (hard to find but good size -- big lots available on ebay: http://www.ebay.com/itm/New-72-Packs-Scrapbook-Double-Sided-Adhesive-Strips-/321157403796 is 3600 strips for $65, or 2c per strip)