Figure 2. The equation for computing NDVI, the Normalized Difference Vegetation Index.
That relationship is a good measure of the amount of photosynthetically active biomass. They quickly settled on an index of plant productivity called NDVI for Normalized Difference Vegetation Index. Instead of just using the difference between the amounts of red and near infrared light, they normalized that difference by dividing it by the total amount of red plus infrared light (Figure 2). That allowed the index from different areas and different times of the day or year to be compared with each other.  _Figure 3. The width of the red and near infrared bands sensed by different satellites and used to calculate NDVI. The earliest satellites are to the left. At far right are the approximate bands captured by the visible/IR camera pair developed for the PLOTS KickStarter campaign. Data from [here](http://rangeview.arizona.edu/Glossary/ndvi.html) and elsewhere._ It was soon demonstrated that NDVI was a pretty good proxy for vegetation health or the amount of photosynthetically active biomass. Dozens of subsequent satellites have returned data about the red and near infrared light reflected from Earth?s surface, and for 40 years NDVI computed from these two bands has been a standard way of describing vegetation health or productivity. Over the years, the exact bands of wavelengths used to compute NDVI differed from satellite to satellite (Figure 3), but the index remained a fairly robust indicator of primary productivity. The most recent satellites sense relatively narrow bands of red and near infrared light.  _Figure 4. A Bayer filter array allowing each pixel on the silicon sensor to record information from either red, green, or blue light._ It is possible to produce a good approximation of NDVI by using a normal consumer grade digital camera to capture visible light (including red), and another similar camera modified to capture only near infrared light. Silicon sensors (both CCD and CMOS) are more or less equally sensitive to all visible wavelengths, but by themselves cannot distinguish among different colors. So red, green, or blue filters are placed over each pixel to record information about just one color (Figure 4). An algorithm then assigns information about all three color channels to each pixel in the image file.  _Figure 5. The spectral sensitivity of a typical silicon sensor with the IR block filter removed. All three color channels include some information about infrared light (wavelengths greater than 700 nm). [Source](http://www.maxmax.com/spectral_response.htm)_ Unlike the human eye, the silicon-based sensors in digital cameras are sensitive to both visible and near infrared light (Figure 5). To prevent infrared light from being recorded in standard digital cameras, a filter opaque to IR is placed in front of the sensor. The resulting color sensitivity of digital cameras mimics human vision (Figure 6). Photo manipulation software can isolate the red channel in a digital image file and use it to compute NDVI.  _Figure 6. ?Typical spectral sensitivities of digital camera sensors with an IR block filter in place. The three colors are recorded separately in ?channels,? and each can be used individually. Information about infrared light is not included in any channel. ?The red channel often includes some information about green light (530-600 nm). [Source](http://www.dxomark.com/index.php/Publications/DxOMark-Insights/Canon-500D-T1i-vs.-Nikon-D5000/Color-blindness-sensor-quality)_ By opening up the camera, removing the IR block filter, and replacing it with a filter that blocks all visible light but passes IR light, a consumer grade digital camera can be made to record only near infrared light. Inexpensive material suitable for such a filter is exposed and developed color negative film (Figure 7), or unexposed developed color slide film. The PLOTS IR cameras had small rectangles of color negative film placed in front of the sensors. Any one or any combination of the color channels from this camera could be used for near IR information, although more IR light seems to be available to the red channel.
Figure 7. Spectral transmission of exposed and developed Kodacolor negative film. All visible light is blocked, and most near infrared light passes through. This type of filter replaced the IR block filter in the Canon A495 cameras modified for the PLOTS KickStarter campaign. Data from: http://www.northcountryradio.com/Articles/irfltr.htm